PC-47 potassium formate

PC-47 potassium formate
Item Inspection Item Specification Result Measured Value Analytical method
Analytical methods
Appearance (25 ℃)
Opaque liquid
Opaque liquid
Opaque liquid
Opaque liquid
Visual inspection
Visual
Viscosity 25 ℃/mpa s 30-50 45
Viscometer
NDJ-5S
Water content (%) 7.5max 6.5
Moisture meter
BYES-2000A
PH value (25 ℃)
Purity content (%)
10-11
42min
ten point five
forty-two
Chemical Safety Data Sheet
PC-47 potassium formate
Part I: Basic Information of Chemicals and Enterprise Identification
Product name: potassium formate
Model: PC-47
Application: Mainly used as polyurethane catalyst.
Contact information:
Shanghai Qiguang Industry and Trade Co., Ltd
Address: 5F, No. 581, Yanchang Middle Road, Shanghai
Tel.:+86-021-56777378
Fax:+86-021-56771922
Part II: Hazard Identification
classification
Not dangerous goods
Potential health hazards
Inhalation: May cause irritation to the nose, throat and lungs Inhalation of high concentrations of vapours and/or smoke may irritate the respiratory system
Eye contact: severe eye irritation
Skin contact: Harmful in contact with skin Slight skin irritation Excessive exposure can cause headache, dizziness, fatigue, nausea and vomiting
Chronic damage to health for a long time: this product does not contain any drug with a concentration greater than or equal to 0.1% that is not subject to Directive 67/549/EEC, IARC, ACGIH and/or
NTP listed carcinogens
Exposure Guidelines
Organ: eyes
Symptoms: Repeated and/or long-term exposure to low concentrations of vapor and/or aerosols may cause: sore throat
Aggravate the disease: adverse eye reaction (such as conjunctivitis or corneal injury) eye disease. Skin abnormalities and allergies
environmental effect
no data
Part III: Composition/Composition Information
Pure product/mixture: mixture
Chemical name CAS No. EC No. Concentration or concentration range
Potassium formate — ≤ 50%
Ethylene glycol — ≥ 50%
Part IV: First aid measures
General advice: Ask your doctor for advice If breathing stops or is difficult, give auxiliary breathing. Oxygen may be required. If the heartbeat stops,
Apply cardiopulmonary resuscitation immediately.
Eye contact: immediately flush the part below the eyelid with plenty of water for at least 20 minutes Remove contact lenses
Skin contact: Rinse immediately with plenty of water for at least 20 minutes
Ingestion: To prevent vomiting, place the victim’s head on the side
Part V: Fire fighting measures
Suitable extinguishing materials: alcohol resistant foam Carbon dioxide (CO2) Dry powder fire extinguisher. Dry sand Lime powder
Special danger: ammonia may be produced Toxic nitrogen oxide gas may be generated
If water is used, it will form a highly toxic water-based solution Do not allow substances generated during fire fighting to flow into sewers or water sources
Incomplete combustion will produce carbon monoxide Personnel at the lower air outlet must be evacuated
Burning produces unpleasant toxic fumes
Special protective equipment for firefighters: use personal protective equipment If necessary, use self-contained breathing apparatus when extinguishing fire
Further information: Do not allow substances generated during fire fighting to flow into sewers or water sources
Hazardous combustion products: carbon monoxide, Carbon dioxide (CO2),
Aldehydes, fragments of flammable hydrocarbons, Organic acid vapor,
When heated above 65 ℃ in a strong alkaline environment, flammable hydrocarbon fragments can be released.
Part VI: Emergency Treatment for Leakage
Personal precautions: use self-contained breathing apparatus and chemical protective clothing Use appropriate protective clothing, gloves and eye/face protection to remove
Evacuate people to a safe area from all fire sources on the site
Environmental precautions: Turn off or remove all ignition sources Build a small dam to prevent proliferation.
Removal method: Carefully enter the area suspected of leakage and absorb it with inert absorbent, such as dry sand Vermiculite. active carbon.
Put in a suitable chemical waste container
Part 7: Processing and Storage
Loading and unloading
Avoid contact with skin and eyes Use only in a well ventilated environment Avoid inhalation of vapors and aerosols Emergency showers and eye washes should be readily available
Observe the working methods stipulated by the government Avoid contact with eyes Use personal protective equipment Do not eat, drink or smoke when using
Storage
Close the container tightly and keep it in a dry, cool and well ventilated place
The product will crystallize, turbid or delaminate after long-term exposure to low temperature If the above conditions occur, the product shall be heated to 100-140 ℉ (38-60 ℃) for one hour and stirred,
Until the product is transparent
Technical measures/preventive measures
Do not store in active metal containers Keep away from open flames, hot surfaces and sources of ignition
Part VIII: Exposure Control/Personal Protection
Loading and unloading
Avoid contact with skin and eyes Use only in a well ventilated environment Avoid inhalation of vapors and aerosols Emergency showers and eye washes should be readily available
Observe the working methods stipulated by the government Avoid contact with eyes Use personal protective equipment Do not eat, drink or smoke when using
Storage
Close the container tightly and keep it in a dry, cool and well ventilated place. The product will crystallize, become turbid or delaminate after long-term exposure to low temperature
Heat the product to 100-140 ℉ (38-60 ℃) for one hour and stir until the product is transparent
Technical measures/preventive measures
Do not store in active metal containers Keep away from open flames, hot surfaces and sources of ignition

Respiratory protection: In case of insufficient ventilation, use appropriate respirator.
Hand protection: neoprene gloves, butyl rubber gloves Sealed gloves The penetration time of the selected gloves must be greater than the estimated service time
Eye protection: wear goggles in the full face mask
Skin and body protection: sealed clothing All rubber clothing Rubber boots or plastic boots Long sleeved shirts and trousers without elastic cuffs
Part 9: Physical and chemical properties
Appearance: liquid
Color: colorless
Odor: No sense of smell
Relative density: no data
Vapor pressure: no data
Boiling point/range: no data
Flash point: no data
Water solubility: no data
Part 10: Stability and reactivity data
Stability: Stable under normal conditions
Forbidden compound:
Active metals (such as sodium, calcium, zinc, etc.)
The substance reacts with hydroxyl compounds
Dehydrating agent
Oxidants
Hazardous decomposition products:
carbon monoxide.
Carbon dioxide (CO2)
aldehyde
Fragments of flammable hydrocarbons
Organic acid vapor
When heated above 65 ℃ in a strong alkaline environment, flammable hydrocarbon fragments can be released.
Hazardous reaction: unknown
Part XI: Toxicological data
Acute health hazard
Ingestion: No data
Inhalation: No data
Skin: LD50:>1000 mg/kg Species: rabbit
Acute eye irritation/corrosion: severe eye irritation
Acute skin irritation/corrosion: slight skin irritation
Part 12: Ecological Information
Ecotoxicity
Water toxicity: no data available
Toxicity to other organisms: No data available
Persistence/degradability
Mobility: No data
Bioaccumulation: No data available
Part XIII: Waste Disposal
Waste disposal method
proposal
Give the product to a professional hazardous waste handler.
Special treatment must be made in accordance with government regulations.
Please refer to relevant state, local and national regulations for proper handling.
Unclean packaging:
Recommendation: It must be handled according to official regulations.
Part 14: Transportation Information
1. International transportation regulations
ADR
Not dangerous goods
IATA
Not dangerous goods
IMDG
Not dangerous goods
2. Special precautions that users need to pay attention to or observe during transportation or conveying
It is not intended to transmit all special management data related to this substance under the transport information of dangerous goods.
Part 15: Regulatory Information
Regulations on the Safety Management of Hazardous Chemicals and other laws and regulations have made corresponding provisions on the safe use, production, storage, transportation, loading and unloading of hazardous chemicals.
Declaration status of national regulations list
USA TSCA listed
EU ELINCS is included in the EINECS directory or is a polymeric substance. The monomer is included in the EINECS directory or is not in the genus
In polymers.
Canada DSL is listed
Australia AICS is listed
Japan ENCS has been listed
Korean ECL has been listed
China SEPA has been listed
Philippines PICCS is listed
Part XVI: Other Information
Reference: no data
Other special considerations: no data available
WARNING: Manufacturing these chemicals from products may pose a fire hazard if used improperly. Each manufacturer and user’s product shall determine whether there are potential hazards in a specific application and take necessary precautions.
Xindian Company only guarantees that its products meet the specifications. Typical properties in the above are regarded as representative of current production and should not be regarded as specifications. All the information provided in this document is considered reliable and represents the best available data
Qiguang does not make any warranty or guarantee, express or implied, for the products, including but not limited to the marketability or applicability for specific purposes, any third party that does not infringe any intellectual property rights, or guarantee the quality or letter and the existing description or sample, and any
Users should fully investigate the products described here, establish appropriate use of any product and bear all risks and responsibilities, because of the use of such products, whether alone or with other substances.
Statement: This information and technical consultation – whether oral, written, or tested – may be corrected and given in good faith without warranty; This applies to third-party proprietary rights that may be involved as well. Application, use and processing of products and products produced by your
On the basis of that, our technical advice is beyond our control, so it is your own responsibility. Our products are sold in accordance with our general terms and conditions of sale and delivery; This does not apply to financial products in this chapter. Because the product specifications are subject to continuous inspection
The certificate can be modified, and the buyer is obliged to check whether the supplier provides the current valid product specifications.